Smarthome 2475SDB Manuel d'utilisateur télécharger pdf (Page 8)

Page 8 of 12 2475SDB - Rev: 1/21/2014 7:58 AM

Resetting In-LineLinc to its Factory Default Settings

The factory reset procedure clears all settings from In-LineLinc, including INSTEON links, X10 addresses,

etc.

Option 1

1) If possible, remove all scene memberships prior to performing the factory reset.

2) Press & hold the Set button on In-LineLinc until it beeps

LED will blink

3) Press & hold the In-LineLinc’s Set button until it beeps again

In-LineLinc’s LED will blink

4) Double-tap the Set button, then immediately press & hold it until the long beep stops

In-LineLinc’s LED will turn off

In-LineLinc will emit a long ((((((Beep))))))

Option 2 – two people required

1) If possible, remove all scene memberships prior to performing the factory reset.

2) Turn circuit breaker off

3) While Pressing & holding In-LineLinc’s Set button, have a friend turn the circuit breaker back on

As you continue to press & hold, In-LineLinc will (Beep)

4) Continue to press & hold the Set button for 3 seconds, then release

As soon as you release the Set button, the In-LineLinc LED will turn on solid white and

then dim. After a few seconds, In-LineLinc will (Beep)-(Beep).

X10 Programming

Instructions on setting X10 primary address and scene addresses can be found online:

http://www.smarthome.com/insteon-x10-programming.html

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Smarthome 2475SDB Manuel d'utilisateur Page 8